Phoenix Gold pm1400 User Manual

DECLARATION OF CONFORMITYWe CARVER PROFESSIONAL INTERNATIONAL(supplier’s name)9300 N. DECATUR, PORTLAND, OR 97203 USA(address)declare under our sole r

970V Distribution SystemsThe pm1400 has sufficient output voltage capability in stereo mode to drive 70-volt distributionsystems without using a step-

970V Distribution SystemsThe pm1400 has sufficient output voltage capability in stereo mode to drive 70-volt distributionsystems without using a step-

Operating TipsUsing the pm1400Once the amplifier has been installed and wired into the system, you are ready to use it. Here aresome tips to help you

Operating TipsUsing the pm1400Once the amplifier has been installed and wired into the system, you are ready to use it. Here aresome tips to help you

13Figure 9Input PolarityThe XLR input connectors on the pm1400 are shipped from the factory with pin 2 hot (+), as indicated on the rear panel. Thepol

13Figure 9Input PolarityThe XLR input connectors on the pm1400 are shipped from the factory with pin 2 hot (+), as indicated on the rear panel. Thepol

Warranty InformationProfessional Power Amplifiers: 5 yearsNOTE:The following warranty is exclusive to the United States and its possessions and territ

Warranty InformationProfessional Power Amplifiers: 5 yearsNOTE:The following warranty is exclusive to the United States and its possessions and territ

DECLARATION OF CONFORMITYWe CARVER PROFESSIONAL INTERNATIONAL(supplier’s name)9300 N. DECATUR, PORTLAND, OR 97203 USA(address)declare under our sole r

CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCKDO NOT REMOVE COVER (OR BACK)NO USER-SERVICEABLE PARTS INSIDEREFE

CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCKDO NOT REMOVE COVER (OR BACK)NO USER-SERVICEABLE PARTS INSIDEREFE

3Continuous Average Output Power, bothchannels driven: 475 watts per channelinto 8 ohms from 20Hz to20kHz, with no more than0.1% THD; 700 watts percha

3Continuous Average Output Power, bothchannels driven: 475 watts per channelinto 8 ohms from 20Hz to20kHz, with no more than0.1% THD; 700 watts percha

6. BRIDGED OPERATIONThe STEREO/MONO switch is located just behind the input panel. This switch is used to select betweenNORMAL STEREO operation, DUAL

6. BRIDGED OPERATIONThe STEREO/MONO switch is located just behind the input panel. This switch is used to select betweenNORMAL STEREO operation, DUAL

AC Power ConsiderationsEnsure that the pm1400 is plugged into an outlet capable of supplying the correct voltage specified for yourmodel and enough cu

AC Power ConsiderationsEnsure that the pm1400 is plugged into an outlet capable of supplying the correct voltage specified for yourmodel and enough cu